Compass CN-M5 Specifications download pdf (Page 37)

CONTROLS

The controls consist of a five position master select switch, and a 9

position membrane keypad. The controls operate as follows:

MASTER SELECT SWITCH

OFF

All power to the autopilot is turned off.

The display will be blank.

STANDBY

The left three digits of the display show

the vessel's current compass heading.

This is the mode the autopilot must be in

to adjust various pre-sets, such as speed

sensitivity, compass heading offset,

minimum brightness, type of special turn

selected or to initiate a full reset.

POWER STEER

The left three digits of the

display show the vessel's current

compass heading. The vessel can be

steered by using the red and green

DODGE &

ARROW

keys to turn the

rudder port or starboard as desired.

The display will switch to show the

vessel's rudder angle whenever a red or

green key is pressed. The display will

continuously show the vessel's rudder

angle if the

TURN

key is pressed.

Compass information can be returned to

the display by pressing the

TURN

key

again.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 68 69

No comments

Compass CN-M5 Specifications Page 37