Compass Mercury 100 User Manual download pdf (Page 30)

5. LCD Icon Guide

1. Battery: Divided into 3 blocks. During normal use, this shows the amount of

power remaining. When charging, the blocks cycle from the bottom up, going from

0 to 3 blocks. Once fully charged, the icon stays at 3 blocks.

2. Satellite: Indicates the GPS positioning status. Blinking means no fix or

scanning for satellites. Constant means position acquired or still acquiring fix.

3. Time: Shows the cumulative riding time. When Reset to 00:00:00, it will start

counting riding time when the user starts riding (reaches 5km/hr). If riding time

exceeds 99:59:59, it hold to 99:59:59.

4. TOA: Time of Arrival. When switched to Waypoint and Route display mode, it

shows the estimated time of arrival.

5. ：Time display.

6. ：Shows the time for the current region. Taiwan, for example, must be set to

UTC +8hr based on the GPS reference time. If GPS fix not acquired, then the time

display changes to --:--:--.

7. DTG: Distance to GO. When switched to Waypoint and Route display modes,

shows the estimated direct line distance.

8. ODO: Odometer. Shows the current distance traveled in MI (miles) or KM

(kilometers).

9. DST: Distance. Displayed in MI or KM. Resets to zero when device is turned on or

off.

10. AZM: Azimuth. Reads the current azimuth from the e-compass and displays it in

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 41 42

No comments

Compass Mercury 100 User Manual Page 30